The original model B with the 26-pin GPIO connector.Over the years there have been some updates: Additionally there is a 2-wire I2C interface and a 4-wire SPI interface (with a 2nd select line, making it 5 pins in total) and the serial UART with a further 2 pins. Two of these pins (on 40-pin Pi’s, just one on 26-pin Pi’s) can be designated for hardware PWM output too. There are 8 general purpose digital I/O pins – these can be programmed as either digital outputs or inputs. The original Raspberry Pi Model A and B version B1 was a $35 single board computer with a 26-pin General Purpose Input/Output (GPIO) connector and this carries a set of signals and buses.
0 Comments
Leave a Reply. |